1. Twin Screw and Barrel
|
| |
Conical Twin Screw and Barrel
|
|
| |
Radhekrishna Extrusions manufactures twin screw & barrels starting from 35 mm to 110 mm screw diameter. Radhekrishna Extrusions manufactures screws and barrels according to present market needs like high filler, low filler application and ISI grade. We, at Radhekrishna Extrusions follow all standard manufacturing process and adhere all standard norms of manufacturing.
|
|
| |
 |
|
| |
|
|
| |
Parallel Twin Screw and Barrel
|
|
| |
Radhekrishna Extrusions manufactures twin screw and barrels starting from 20 mm to 150 mm screw diameter. |
|
| |
 |
|
2. Single Screw and Barrel
|
| |
Radhekrishna Extrusions manufactures single screws and barrels starting from 20 mm to 150 mm screw diameter.
Grooved feed barrel
|
 |
| |
The grooved feed barrel is used for achieving high shear and better transportation of material. As Co-efficient of friction between granules and screw and barrel should be higher to get proper melting of the material, It’s imperative to have grooved feed in the barrel for processing of polymers of Olefin group.
Application:
- LDPE/HDPE/PP Film
- Raffia/ Mono Filament Application
|
| |
Barrier Screw
|
| |
The barrier screw design separates melted material from unmelted solid material into separate channels. This unique mixing feature thoroughly homogenizes the melt with little or no increase in its average temperature. Mixing is achieved with an undulating root profile in the metering zone of the screw.
Application:
- LDPE/HDPE/PP Film
- PVC cable
- ABS
- PVC Pipe/PVC profile
|
| |
Moddoc – barrier screw
|
| |
Maddoc barrier screw is used to break down particles by forcing material to flow over barrier flights, in a similar manner to barrier screws.
Application:
- HDPE Pipes
- XLPE cables
- Lay Flat Pipe,
- LLDPE Tubing
- PP film
|
3. Die and segmented Barrel
|
<< Back |
| |
Segmented Barrel
Standard Features
|
| |
- Range: Bore Diameter 20 mm to Diameter 125 mm
- Sleeve:
HSSM2 Grade sleeve for better wear resistance-through hardness – HRC 62-63 or Nitrided sleeve made from EN-41-B material-layer hardness
- Outer body made from EN-8 material
- Dwelling and Drilling operation by using accurate jigs & fixtures
- Both faces ground and lapped
|
| |
Air bubble ‘T’ Die
Standard Features
|
| |
- Range of die-600mm to 2500mm Flat
- High quality hard steel body with hard chrome plating
- Special cartring and Flat heaters for optimum heating
- Temperature sensor for optimum sensing
- Adjustable lip thinkness
- Ground surface Flatness for leak proof sealing
- Face sealing through TEFlON Sheet
|
| |
Lamination/Coating/Sheet Die:
Standard Feartures
|
| |
- Range Range of die-100mm to 5000mm Flat
- High quality hard steel body with hard chrome plating
- Special cartring and heaters for optimum heating
- Temperature sensor for optimum sensing
- Special cavity angel for uniform flow
- Adjustable lip thinkness
- Ground surface flatness for leak proof sealing
- Face sealing through TEFLON sheet
|
|
